PERHITUNGAN TEGANGAN POROS MODEL PROPELLER PADA UJI SELF PROPULSION MODEL KAPAL

Suyadi Suyadi, ahmad syafiul

Abstract


Shaft and propeller is the main function of the implementation of model self-test model self-declaration is a routine work done in BTH - BPPT. Axis serves to move or forward power from transmission to propeller so that the propeller can rotate. The shaft is made of steel pipe or stainless steel (AISI 1020) which has resistance to twist or bending force. Therefore a technical study of the magnitude of torsion and bending stress is necessary for predicting the life of the shaft. To obtain the shaft life is calculated in the propulsion test process where the variable chosen in the propulsion test process is the velocity of the vessel model which is the parameters that influence the force, torque and tension changes. The results of this study indicate that for the model speed of 1.529 m/s obtained the maximum stress 31.75 Mpa / 4.63 Ksi axis operates in normal conditions while the allowable voltage allowable 294,74 Mpa / 42,75 Ksi

Keywords


Force,toque,stress,propulsion.

Full Text:

PDF


DOI: https://doi.org/10.35314/ip.v9i2.1106

Refbacks

  • There are currently no refbacks.


Copyright (c) 2019 INOVTEK POLBENG


This Journal has been listed and indexed in :

         

Creative Commons License
inovtek polbeng by http://ejournal.polbeng.ac.id/index.php/IP is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License